Three trucksThree modules16 MW

72 hours to power

Three standard truckloads arrive at a prepared pad. A crane sets three 40 ft modules, the crew makes one hot joint and plugs in four 800 V DC busways, and the unit makes power on the third day.

Engineering target, not yet validated

Hour 0 of 72Day 1

The plan, to scale

Seventy-two hours, task by task

The bars are drawn to the hour. Select one to jump the movie to that point; the line follows the movie as it plays.

One crane, one crew per shift, around the clock. Tasks overlap where they touch different modules.

Before hour 0

Ready when the trucks arrive

The 72 hours start with the site prepared. None of this is in the clock.

Concrete pads or piles for the three modules, Module 3 beside Module 2
Gas tie-in point at the pad, metered and isolated
Busway route and supports to the data hall, four entries in its wall
Water supply and drain for the exhaust module
Crane booked, ground bearing checked, lift plan approved
Permits in hand; modules flushed and loop-checked in the factory

What arrives

Three 40 ft high-cube modules

Each module is a standard container load, sized for a step-deck trailer. The engine and generators share Module 1, so the shaft is aligned in the factory, not on site.

Module 1 · load 1

Power

Hyper Tech generators on the engine shaft, the core on pull-out rails, the power bay with four 800 V DC busbars. Filter house craned onto its roof on site.

Module 2 · load 2

Exhaust

Exhaust treatment, with the stack traveling inside and stood on its roof flange on site. Bolted end to end with Module 1.

Module 3 · load 3

Auxiliaries

Fuel gas skid, lube oil, controls. Stands alongside Module 2; the filter house rides in it to site.

Why it can be quick

Few joints, made in the factory

5crane lifts: three modules, the filter house, the stack

1hot joint made on site: the exhaust flange between Modules 1 and 2

4busway connections, one per 800 V DC bus, plugged in

0shaft alignments on site

Storyboard

Six moments from the install

Frames from the same animation, side elevation to scale. Select one to play from there.

For comparison

How mobile gas turbine plants are installed today

Plant	Output	Delivered as	Install
GE Vernova TM2500	≈ 35 MW	Three trailers	About 14 days
Solar Turbines SMT60	5.7 MW	One trailer	Under six hours
Hyper Tech CROSSOVER	16 MW	Three 40 ft modules	72 hours (target)

Public sources: GE Vernova TM2500 · APR Energy TM2500 GEN8 · Solar Turbines mobile power.